Product Specifications

Viscosity:	Flash Point:	Density (lb/gal):	Solid (% by weight):	Solid (% by volume):	Shelf Life (months):
N/A	-4°F (-20°C)	~6.8	0 – 2.0%	0 – 1.0%	24

Product Description

The Promatch Dye line consists of dyes dissolved in a non-grain raising solvent blend. These products have brighter colors and better clarity than wiping and spray stains.

Uses

Dyes are used as a first coat on wood to give bright, clear, transparent effects. It is adequate for interior exposure on expensive furniture, but is not designed for exterior exposure. 

Environmental Data (as supplied)

VOC less exempt lb/gal:	VOC lb/gal:	VOC less exempt g/l:	VOC g/l:	VOC lb/lb Solid:	VHAPs lb/lb Solid:
< 7.5	<1.7	< 900	< 205	< 26	<0.1

Note:

N/A

Application Data

Suggested Uses:	Mixing Ratio:	Pot Life:	Application Viscosity:	Reducer:	Retarder:	Clean-up Solvent:	Recommended Wet Film:	Coverage:
Wood Stain	N/A	N/A	N/A	890-8500	N/A	800-5500	N/A	Wood substrate should be sanded with 120, 150 or 180 grit paper prior to staining or coating. Wood must be well sanded and without large imperfections.

Note:

N/A

Surface Preparation

Wood substrate should be sanded with 120, 150 or 180 grit paper prior to staining or coating. Wood must be well sanded and without large imperfections. 

 

General Information

Most of these products can be applied by spraying as received but can also be reduced any amount with 890-8500 clear base.

Toner penetrates deeply and cannot be worked in, like wiping stains, in order to achieve uniformity. Birch is especially suitable for Toner.

IMPORTANT:  Product must be thoroughly agitated before use.

 

THE CUSTOMER IS RESPONSIBLE FOR FOLLOWING THE RECOMMENDED APPLICATION PROCEDURES. FAILURE TO ADHERE TO THE RECOMMENDATIONS GIVEN IN THIS DATA SHEET WILL LIKELY RESULT IN UNSATISFACTORY FILM APPEARANCE OR FILM FAILURE. THE COMPLETE COATING SYSTEM SHOULD BE CHECKED FOR REQUIRED PROPERTIES PRIOR TO THE START-UP OF PRODUCTION.

Drying Times

Room Temperature (68°F)

Tack Free Time:	Dry to Sand:	Dry to Stack:
N/A	N/A	N/A

Forced Drying Schedule (122°F)

Tack Free Time:	Dry to Sand:	Dry to Stack:
N/A	N/A	N/A

Note:

Drying time is very short and 10 – 15 minutes is sufficient prior to washcoating.  However, heavy coats in dark colors followed by filler should get at least ½ hour drying.

---

Dry times are greatly affected by film build, porosity of substrate, air movement as well as heat and humidity. Temperatures are based on actual board temperature. This may vary depending on length of time for boards to reach these temperatures. Minimum curing temperatures of 64°F/18°C must be maintained throughout the curing cycle to achieve the film integrity as stated in product features.