Product Specifications

Viscosity:	Flash Point:	Density (lb/gal):	Solid (% by weight):	Solid (% by volume):	Shelf Life (months):
N/A	82F (28C)	Varies (9-15)	Varies (72-86)	Varies (63-68)	24

Product Description

866 Colorants are medium-oil alkyd based tints designed for use in solvent-borne industrial coatings.  They are widely compatible and available in a broad spectrum of colors.  

Note: Shelf life is 24 months if unopened

Uses

This product line is designed as a colorant for solvent-borne coatings and stains. 

Environmental Data (as supplied)

VOC less exempt lb/gal:	VOC lb/gal:	VOC less exempt g/l:	VOC g/l:	VOC lb/lb Solid:	VHAPs lb/lb Solid:
N/A	N/A	N/A	N/A	N/A	N/A

Note:

N/A

Application Data

Suggested Uses:	Mixing Ratio:	Pot Life:	Application Viscosity:	Reducer:	Retarder:	Clean-up Solvent:	Recommended Wet Film:	Coverage:
Tinter	See individual product sheets	N/A	See individual product sheets	N/A	N/A	803-1298	N/A	N/A

Note:

N/A

Surface Preparation

N/A

General Information

Follow recommendations found on Product Information Sheets of materials using this product.  Different base materials will accept more or less of these colorants depending on use.

Proper handling is essential to maintain quality and consistency over time.  Colorants must be mixed prior to use.  Containers should be tightly sealed when not in use.  If the colorant level is less than 20% of the package volume it is recommended to repack into smaller container if material is going to be stored for an extended period of time.

Refer to the Material Safety Data Sheet for important information on safety and handling for this material.

Vapor and liquid are irritating to skin and eyes.  Wear goggles and gloves where there is danger of contact with the liquid.

THE CUSTOMER IS RESPONSIBLE FOR FOLLOWING THE RECOMMENDED APPLICATION PROCEDURES. FAILURE TO ADHERE TO THE RECOMMENDATIONS GIVEN IN THIS DATA SHEET WILL LIKELY RESULT IN UNSATISFACTORY FILM APPEARANCE OR FILM FAILURE. THE COMPLETE COATING SYSTEM SHOULD BE CHECKED FOR REQUIRED PROPERTIES PRIOR TO THE START-UP OF PRODUCTION.

Drying Times

Room Temperature (68°F)

Tack Free Time:	Dry to Sand:	Dry to Stack:
N/A	N/A	N/A

Forced Drying Schedule (122°F)

Tack Free Time:	Dry to Sand:	Dry to Stack:
N/A	N/A	N/A

Note:

N/A

---

Dry times are greatly affected by film build, porosity of substrate, air movement as well as heat and humidity. Temperatures are based on actual board temperature. This may vary depending on length of time for boards to reach these temperatures. Minimum curing temperatures of 64°F/18°C must be maintained throughout the curing cycle to achieve the film integrity as stated in product features.