545-5200 Variset® Select White Pre-Cat Pigmented Vinyl Primer

Variset Select White Vinyl Primer is recommended for use as a primer for Variset Select Topcoat.  It has good filling properties and hiding characteristics.

Substrate should be sanded using 120, 150 or 180 grit stearated paper prior to coating. Variset Select White Vinyl Primer should be sanded with 280/320 grit stearated paper prior to being coated and the next coat must be applied within eight hours of sanding. Variset Select White Vinyl Primer cannot be used on metal, old oil or cellulose lacquers.

Agitate material before use. Always mix Variset Select White Vinyl Primer while adding  reducers in the recommended mixing ratio. Variset Select White Vinyl Primer must be agitated thoroughly at all times to ensure product consistency.
Apply at 3 - 5 mils wet to sanded substrate.  Further coats may be applied after complete drying followed by sanding with 280/320 grit stearated paper.
Maximum film build of Variset Select White Vinyl Primer should not exceed 2 - 3 mils dry.  Maximum film build of total coating system must not exceed 4 mils dry.  Contact with metal surfaces should be avoided.
Variset Select White Vinyl Primer must not be polluted with oil, varnish or the like and must not be sanded with steel wool between coats.
Variset Select White Vinyl Primer must not be used and dried at temperatures below 64°F or relative humidity above 65%. During the curing process, the coating must not be exposed to ammonia vapors. Ammonia cleaners should not be used for cleaning the finish surfaces. This may accelerate discoloration.