131-71XX Variset® Plus Pre-Cat Pigmented TC

Variset Plus is recommended for kitchen cabinets, office and household furniture, as well as other interior wood applications.

Wood substrate should be sanded with 120, 150 or 180 grit paper prior to coating. Primers should be sanded with 280/320 grit stearated paper prior to topcoating. An appropriate primer is Variset Primer or self-seal. When recoating, the previous coat of Variset Plus or Variset Primer must be sanded and the next coat applied within eight hours. Variset Plus cannot be used on metal, old oil or cellulose lacquers.

Agitate material before use. Always mix Variset Plus while adding hardener and reducers in the recommended mixing ratios. Variset Plus must be agitated thoroughly at all times to ensure product consistency and consistent gloss.

Apply at 3-5 mils wet on sanded or primed substrate. Further coats may be applied after complete drying followed by sanding with 280/320 grit stearated paper. Maximum film build of Variset Plus should not exceed 4 mils dry. Maximum film build of total coating system must not exceed 4 mils dry. The second and subsequent coats must be applied the same day as the previous coat is sanded.

Contact with metal surfaces should be avoided.

Variset Plus must not be polluted with oil, varnish or the like and must not be sanded with steel wool between the coats. Variset Plus must not be used and dried at temperatures below 64°F or relative humidity above 65%. During hardening, the enamel must not be exposed to ammonia vapors. Ammonia cleaners should not be used for cleaning the finished surface. This may accelerate discoloration.