635-0XX Dancryl Acrylic Post-Cat Clear TC

Dancryl is used on interior wood when clarity and light stability are very important.

Wood substrate should be sanded with 120, 150 or 180 grit paper prior to staining or coating. Sealers should be sanded with 280/320 grit stearated paper prior to topcoating. Appropriate sealers are self seal or catalyzed 401 line vinyl sealer. When recoating, the sealer or previous coat must be sanded and the next coat applied within eight hours. Stain systems under acid containing coatings should be acid stable. Dancryl can not be used on metal, old oil or cellulose lacquers.

Agitate material before use. Always mix Dancryl while adding hardener and reducers in the recommended mixing ratios. Dancryl must be agitated thoroughly at all times to ensure product consistency and consistent gloss.
Apply at 3-5 mils wet on sanded substrate. Further coats may be applied after complete drying followed by sanding with 280/320 grit stearated paper.
Contact with metal surfaces should be avoided.
Maximum film build of Dancryl should not exceed 4 mils dry. Maximum film build of total coating system must not exceed 4 mils dry.

To obtain a complete cure, the system should be applied at an ambient temperature above 18ºC and a relative humidity below 65%. When drying, this product is not to be exposed to ammonia vapors. Finished surfaces must not be cleaned with ammonia containing products.

This product could be used as a self seal or over catalyzed vinyl sealer 401-004.