545-8006 Optiprime Neutral Pre-Cat Pigmented Primer

Interior wood applications

Substrate should be sanded using 120, 150 or 180 grit stearated paper prior to coating. Primers, if used, should be sanded prior to being coated with 280/320 grit stearated paper. When recoating, the previous coat of Optiprime must be sanded and the next coat applied within eight hours. Optiprime cannot be used on metal, old oil or cellulose lacquers.

Agitate material before use. Always mix Optiprime while adding hardener and reducers in the recommended mixing ratios. Optiprime must be agitated thoroughly at all times to ensure product consistency.
Apply at 3-5 mils wet on sanded substrate. Further coats may be applied after complete drying followed by sanding with 280/320 grit stearated paper. The second and subsequent coats must be applied the same day as the previous coat is sanded.
Maximum film build of Optiprime should not exceed 2-3 mils dry. Maximum film build of total coating system must not exceed 4
mils dry. Contact with metal surfaces should be avoided.
Optiprime must not be polluted with oil, varnish or the like and must not be sanded with steel wool between the coats. Optiprime
must not be used and dried at temperatures below 18°C or relative humidity above 65%. During hardening the enamel must not be exposed to ammonia vapors. Ammonia cleaners should not be used for cleaning the finished surface.This may accelerate discoloration.

Topcoats to use over 545-8006: 131-51XX, 131-82XX, 431-90XX, 431-98XX.