117-69XX PLASTICOLOR® RTS Neutral Topcoat

PLASTICOLOR® Neutral RTS is recommended for kitchen cabinets, high build office or residential furniture as well as other interior wood applications. PLASTICOLOR® Neutral RTS is an all-round coating suitable for application with various
spraying equipment.

Primer should be sanded using 280 and 320 grit stearated paper. Suitable primers are Plastiprimer 522-1410, Plastiprimer off white 220-214, Omnibuilt 522-3500 or Chemlife® 24 White Primer 522-2500 for MDF and solid woods like Maple and Oak. Primers should be topcoated within eight hours of sanding. Care should be taken during sanding to avoid sanding through the primer

Catalyze and reduce the material as recommended. To ensure proper sheen, the catalyzed material should be agitated at all times. Apply 3 to 5 wet mils on sanded surface. One or two extra coats can be applied following a complete cure and a
sanding with a #280/320 paper. Maximum film build of the system should not exceed 6 mils dry. PLASTICOLOR® Neutral RTS must not be polluted with oil, varnish or the like and must not be sanded with steel wool between coats. Avoid all contact with metallic surfaces. To obtain complete cure, PLASTICOLOR® Neutral RTS must be applied at a temperature above 18ºC/68°F and relative humidity below 65%. When drying, this product should not be exposed to ammonia vapors. Finished surface must not be cleaned with ammonia containing products. Always use containers and equipment made of plastic or stainless steel to avoid discoloration of the material due to oxidation.

THE CUSTOMER IS RESPONSIBLE FOR FOLLOWING THE RECOMMENDED APPLICATION PROCEDURES. FAILURE TO ADHERE TO THE
RECOMMENDATIONS GIVEN IN THIS DATA SHEET WILL LIKELY RESULT IN UNSATISFACTORY FILM APPEARANCE OR FILM FAILURE. THE
COMPLETE COATING SYSTEM SHOULD BE CHECKED FOR REQUIRED PROPERTIES PRIOR TO THE START-UP OF PRODUCTION