117-10XX Plasticolor White Post-Cat Pigmented TC

Plasticolor is used as the final coat over wood, plywood, chipboard, etc., meant for interior use. This product is recommended for kitchen cabinets, high build office or residential furniture as well as many other interior wood applications where high build and durability are required. 

Primer should be sanded using 240 and 320 grit stearated paper. Suitable primers are Plastiprimer MDF 522-1410, Plastiprimer White 522-1420 or Chemlife® 24 White Primer 522-2400 for solid woods like Maple and Oak. Primers should be topcoated within eight hours of sanding. Care should be taken during sanding to avoid sanding through the primer.

Catalyze and reduce the material as recommended. Plasticolor White is applied in one or two coats and can be used both as a primer and enamel on all kinds of wood meant for interior use. A premium system is however, obtained through priming with Plastiprimer MDF 522-1410, Plastiprimer White Hardwood 522-1420 or Chemlife 24 White Primer 522-2400.

A thorough sanding between the coats is essential to the adhesion. The second and subsequent coats must be applied the same day as the previous coat is sanded. Plasticolor White cannot be used on metal, old oil or cellulose lacquers.

Total recommended film build of primer and Plasticolor White 117-10XX is not to exceed 6 mils dry. Over the primer, the topcoat should not exceed 4 mils dry.

To ensure proper sheen, the catalyzed material should be agitated at all times. Plasticolor White must be thoroughly stirred, while adding catalyst and thinner in the recommended mixing ratio. Contact with metal surfaces should be avoided once the Plasticolor White has been catalyzed.

Plasticolor White must not be polluted with oil, varnish or the like and must not be sanded with steel wool between coats. Plasticolor White must not be used and dried at temperatures below 65°F (18°C) or relative humidity above 65%. During the curing process, the coating must not be exposed to ammonia vapors. Ammonia cleaners should not be used for cleaning the finished surface. This may accelerate discoloration.