- CHEMLACK Topcoat
- 441-51XX Chemlack 275 NC Clear TC
- Product Codes:
441-5110 Matte
441-5120 Low Gloss
441-5140 Satin
441-5160 Semi-Gloss
441-5190 High Gloss - Surface Preparation:
Substrate must be sanded using 120, 150 or 180 grit stearated paper prior to staining or coating. Sealers should be sanded with 240, 280 and 320 grit stearated papers prior to being coated. Appropriate sealers are Chemcraft lacquer sealers or self-seal. Appropriate stains are 825-39XX series stains or 824-50XX series waterborne stains.
- General Information:
Agitate material before use. Chemlack 275 must be agitated thoroughly at all times to ensure product consistency. Apply 3-5 wet mils on sanded substrate. Further coats may be applied after complete drying followed by sanding with 280/320 grit stearated paper.
Maximum film build of Chemlack 275 should not exceed 3 mils dry. Maximum film build of total coating system must not exceed 3 mils dry.
- PDF Name: US-PIS_441-51XX_Chemlack_275_NC_Clear_TC
- Tack Free Time: 10 minutes
- Files: US-PIS_441-51XX_Chemlack_275_NC_Clear_TC.pdf
- Dry to Sand : 20 - 25 minutes
- Dry to Stack: 2 - 3 hours
- Tack Free Time: Flash off before entering oven
- VOC less exempt lb/gal: <2.29
- Dry to Sand: 15 – 20 minutes
- VOC lb/gal: <0.60
- VOC less exempt g/l: <275
- VOC g/l: <72
- VOC lb/lb Solid: <0.35
- Dry to Stack: 60 – 90 minutes
- VHAPs lb/lb Solid: <0.001
- Note:
N/A
- spec_description:
Chemlack 275 is a single component nitrocellulose lacquer that provides good depth and clarity. This product has been formulated to meet 275 g/L VOC regulations.
- spec_uses:
Chemlack 275 is recommended for household furniture, millwork, decorative items as well as many other interior wood applications
- Suggested Uses:
Wood Finish
- Mixing Ratio:
N/A
- Pot Life:
N/A
- Application Viscosity:
Zahn #2 signature cup 18 – 22 seconds
- Reducer: 803-1325 or 803-1349
- Retarder: 800-5915
- Clean-up Solvent: 800-5500
- Recommended Wet Film: 3 – 5 mils
- Coverage:
270 sq. ft/gal at 1 mil dry and at 100% transfer efficiency. Coverage will vary depending on method of application or coating thickness.
- Note application:
The addition of these reducers or retarders could affect 275 VOC compliance.
- Viscosity:
Zahn #2 signature cup 22 sec at 77°F
- Flash Point: 0°F (-18°C)
- Density (lb/gal): 7.58
- Solid (% by weight): 23%
- Solid (% by volume): 17%
- Shelf Life (months): 12