- Promatch Spray Stain Base
- 890-2200 Promatch Spray Stain Base
- Product Codes:
890-2200
- Surface Preparation:
Wood substrate must be sanded using 120, 150, or 180 grit paper prior to staining. On wood such as maple, coarser sanding, such as 150 grit, should be performed to avoid polishing of the wood surface. Hand sanding in the direction of the grain following orbital sanding will remove swirl marks.
- General Information:
Product must be thoroughly agitated before use and during application for color consistency. Apply a wet coat of the spray stain on the sanded surface. Let dry a minimum of 30 minutes air dry before the application of the sealer. Keep under mixing to assure consistency of the product. Can be tinted with 844 tints and/or with dyes at a maximum of 6% volume.
- PDF Name: US-PIS_890-2200_Promatch_Spray_Stain_Base
- Tack Free Time: N/A
- Files: US-PIS_890-2200_Promatch_Spray_Stain_Base.pdf
- Dry to Sand : N/A
- Dry to Stack: N/A
- Tack Free Time: N/A
- VOC less exempt lb/gal: <7.15
- Dry to Sand: N/A
- VOC lb/gal: <7.15
- VOC lb/lb Solid: 0.00
- Dry to Stack: N/A
- VHAPs lb/lb Solid: 0.00
- Note:
See individual compliance sheets for specific data.
- spec_description:
Ready to use spray stain that gives little or no grain raising. Formulated especially to be tinted with 844 colorants. Its unique solvent blend also gives the option of using dyes for the development of rich and deep colors.
- spec_uses:
This product is intended for interior wood application.
- Suggested Uses: Wood Stain
- Mixing Ratio:
N/A
- Pot Life: N/A
- Application Viscosity:
N/A
- Reducer: N/A
- Retarder: N/A
- Clean-up Solvent: Acetone or Lacquer Thinner
- Recommended Wet Film: N/A
- Coverage:
N/A
- Note application:
N/A
- Viscosity:
N/A
- Flash Point: 25°F CC
- Density (lb/gal): 7.28 +/-0.20
- Solid (% by weight): 1.89
- Solid (% by volume): 1.42
- Shelf Life (months): 12 mo